Drag Cartel Kinsler ITB Throttle Bracket

Drag Cartel Kinsler ITB Throttle Cable Bracket

If you're running Drag Cartel Racing Kinsler ITBs, this bracket isn't optional - it's how your throttle cable actually works. The factory throttle cable bracket bolts to your stock throttle body. Pull that off for ITBs and you've got a throttle cable with nowhere to anchor. This billet aluminum bracket gives it that fixed mounting point, so your cable pulls the throttle linkage instead of just flopping around. No anchor means sloppy throttle feel and inconsistent response - exactly what you don't want on a setup you're building for performance.

Why the Factory Bracket Doesn't Cut It

The stock throttle cable bracket is built around the geometry of your factory throttle body. Swap to ITBs and that geometry's gone. The cable housing needs a solid, fixed anchor point - if it moves even slightly under load, the effective cable travel changes and your throttle gets mushy and unpredictable. This bracket restores that anchor point, matched specifically to Drag Cartel's Kinsler ITB kit geometry. It bolts on without drilling, cutting, or modifying anything. That's the whole point of buying the right part instead of fabricating something.

Built from Billet, Finished to Last

Drag Cartel machines this bracket from billet aluminum - not stamped, not cast. Then they hard anodize it black. Hard anodizing isn't just cosmetic. It penetrates the aluminum surface and creates a layer that resists corrosion, wear, and the kind of heat cycles your engine bay throws at everything bolted to it. The contact points where your cable housing mounts will stay tight and won't wear out on you after a season of hard driving.

Heads Up Before You Install

Once the bracket's on, route your throttle cable without any kinks and dial in the adjustment so you hit wide-open throttle cleanly and close fully with zero binding or preload. Before you fire the car, push the throttle pedal to the floor and confirm the throttle snaps shut the moment you release it. A sticky or slow-returning throttle on an ITB setup is dangerous - don't skip this check.

What's in the Box

• Drag Cartel Kinsler ITB throttle cable bracket (DC-THR-BRK)
• Billet aluminum construction
• Hard anodized black finish
• All mounting hardware included

Compatible With

• Drag Cartel Edition Kinsler ITB kits only

Note: This bracket only fits Drag Cartel's Kinsler ITB kits. It won't work with other ITB setups. Don't guess - if you're not running Drag Cartel Kinsler ITBs, this isn't your bracket.