Honda RD1 CR-V/DC5 RSX Hood Prop Holder 90602-S10-003

Honda Hood Prop Rod Holder - 90602-S10-003

Your hood prop rod flopping around loose because the plastic clip's broken or missing? Honda part number 90602-S10-003 is the OEM plastic retaining clip that holds your hood prop rod when it's not being used. It clips onto your radiator support or fender and keeps the prop rod secure when your hood's closed. Without it, your prop rod rattles around in the engine bay or falls out completely. Maybe you're hearing rattling every time you drive or you've lost your prop rod somewhere on the highway. A fresh clip fixes it.

Why This Clip's Always Missing

This plastic clip breaks or goes missing all the time. Someone's working under the hood, accidentally snaps the clip off, and doesn't bother replacing it. Or the clip gets brittle after 15-20 years of heat cycling in the engine bay and it cracks. Once it's broken, your prop rod just dangles there with nothing holding it. Every bump you hit, the rod's bouncing around and rattling. Eventually it falls out and you lose it.

What You Get

• Honda OEM hood prop rod holder (part number 90602-S10-003)
• Plastic retaining clip for hood prop rod
• Clips to radiator support or fender
• Holds prop rod secure when hood is closed
• Prevents prop rod from rattling or falling out
• Same clip your car came with from the factory

Fits Your Car

• 2002-2006 Acura RSX (DC5)
• 1998-2001 Honda CR-V (RD1, 1st gen)
• 2010-2014 Honda Insight
• 2009-2015 Honda Pilot

Note: The clip just snaps into place on your radiator support or fender. Find the hole where the old clip used to be (or where it's supposed to go if you've never had one) and push the new clip in until it clicks. Then slide your prop rod into the clip. Make sure the rod's seated in the clip properly or it'll rattle. If you can't find where the clip mounts, check your hood prop rod for a bend or hook near the bottom. That's the end that goes in the clip. The clip mounts wherever that end naturally rests when your hood's closed.