Honda K20A2/A3 Throttle Body Gasket 16176-PRB-A01

Honda OEM Throttle Body Gasket - K20A2/K20A3 Engines

Pulling your throttle body on your RSX or Civic Si for cleaning or replacement? You'll need a new gasket. This is the genuine Honda throttle body gasket for K20A2 and K20A3 engines. It seals the mating surface between the throttle body and intake manifold so you don't get vacuum leaks that cause rough idle, poor throttle response, or lean running conditions. Reusing the old gasket after it's been disturbed is how you end up chasing a vacuum leak you didn't have before the job. Part number 16176-PRB-A01.

Replace It Every Time the Throttle Body Comes Off

Throttle body gaskets compress when they're torqued down, which is how they seal. Once you unbolt the throttle body, the gasket won't seal properly if you try to reuse it. A vacuum leak at the throttle body causes rough idle, hesitation, and lean codes. It's a cheap part that takes two seconds to swap in, so there's no reason to skip it.

Fits Your Car

• 2002-2006 Acura RSX (K20A2, K20A3)
• 2002-2005 Honda Civic Si EP3 (K20A3)

Compatible Engines

• K20A2 (Acura RSX Type-S)
• K20A3 (Acura RSX Base, Civic Si EP3)

Specifications

• Honda part number: 16176-PRB-A01
• Genuine Honda OEM replacement
• Throttle body gasket for K20A2/K20A3 engines

Note: Always replace the throttle body gasket when removing the throttle body. Reusing the old gasket causes vacuum leaks. Clean both mating surfaces thoroughly before installing the new gasket.